The Ford Barn - View Single Post

old31 · 11-29-2019, 05:05 AM

I have the same problem and its frustrating to spend so much time on 1 bolt.

So I got a 10" rod a little smaller than bolt size. I beveled a v on one side. The v side is then put in from the firewall side till the point comes out of the radiator side. This will align the gen to the bracket.

I then slowly pull out the rod as I slowly slide in the generator bolt from the radiator side.

11-29-2019, 05:05 AM	#5
old31 Senior Member Join Date: Jan 2016 Posts: 2,096	Re: Install generator I have the same problem and its frustrating to spend so much time on 1 bolt. So I got a 10" rod a little smaller than bolt size. I beveled a v on one side. The v side is then put in from the firewall side till the point comes out of the radiator side. This will align the gen to the bracket. I then slowly pull out the rod as I slowly slide in the generator bolt from the radiator side.