View Single Post
Old 04-29-2019, 08:24 PM   #13
RalphM
Senior Member
 
RalphM's Avatar
 
Join Date: Nov 2015
Location: North Pole, Alaska
Posts: 2,466
Default Re: 35 floor thickness?

So I found some steel, had the panels cut. They look OK but I thought I’d measure them today and I came up with .057 thickness, which is a tad on the heavy side. Hopefully it won’t be too hard to roll a bead in them. Plus side is, they did a real good job of cutting and bending them to just what I wanted. Not too bad a price either cost me I think $65 for everything, three pieces.
I would have to of paid double that for the pieces to be shipped here.

But after all the work I’ve done on my fenders I cannot believe they are the same thickness of steel. Seems like they are a lot thinner.
RalphM is offline   Reply With Quote