The Ford Barn - View Single Post

Jim Brierley · 09-17-2019, 10:49 AM

.004" is more than enough, .002" is all that is needed because the only consideration is expansion on about 1.5" of steel cam.

09-17-2019, 10:49 AM	#12
Jim Brierley Senior Member Join Date: Jun 2010 Location: Temecula, CA Posts: 4,091	Re: Timing gear/cam noise? .004" is more than enough, .002" is all that is needed because the only consideration is expansion on about 1.5" of steel cam.