Thread
:
Head Studs
View Single Post
11-08-2013, 05:31 AM
#
10
Bruce of MN
Senior Member
Join Date: May 2010
Location: VA
Posts: 1,411
Re: Head Studs
It may not be the head stud holes, but isn't there some place where the proper tap used at the factory is one with less clearance and the tap from Ace is too loose with NOS studs? I don't know if this applies to modern studs.
Bruce of MN
View Public Profile
Send a private message to Bruce of MN
Find More Posts by Bruce of MN