Re: 1956 Fairlane Victoria flex plate 292 fordomatic question
Again, those are reinforcing plates. They were used with the original flex-plate install and used with the SERVICE REPLACEMENT flex-plate install he is showing (same PN and number of reinforcing plates).
I doubt if anything needs to be re-balanced as FORD would have the same balance between the early and late or most likely would have not superseded the original part with the later design.
Proper attaching cap screw length and grade must also be verified.
How they are placed will affect ring gear - starter drive engagement position as well as convertor to front pump engagement clearance.
The FORDOMATIC SHOP MANUAL is a must here if there were no plates on disassembly.
__________________
*****
- DISCLAIMER -
The above posted information is in my opinion only (IMO) and may contain copy and paste material(s).
In addition, any above tech information is supplied in good faith. No responsibility implied or otherwise can be accepted for the way others use or interpret provided data.
Your experience(s), opinion(s) and mileage may vary.
DIAGNOSED CDO - (OCD In Correct Alphabetical Order)
|