View Single Post
Old 06-26-2010, 08:15 PM   #14
John Butts in CT
Senior Member
John Butts in CT's Avatar
Join Date: May 2010
Location: Southeastern Connecticut
Posts: 464
Default Re: Rotor gap to distributor body terminals

We're on the same page, MrTube. The dimensions of your new cap may be fine, but just think how your engine would sound (or not sound at all) if you hadn't cleaned off that "flash."

No disrepect to our many fine parts houses (thank you all), but the distributor body on the shelf today may differ a bit from the thousands of distributor caps on the line at River Rouge, '27 - '31.

Just saying, "before you bolt it on, check it out."
John Butts in CT is offline   Reply With Quote