View Single Post
Old 03-23-2018, 11:14 AM   #15
Garagekulture13
Senior Member
 
Garagekulture13's Avatar
 
Join Date: Nov 2015
Location: Tennessee
Posts: 110
Default Re: Chasing the knock.

Quote:
Originally Posted by George Miller View Post
It is really hard to tell by the picture, but it looks like your timing gear teeth are worn real bad.
To find the noise it is best to short out each cylinder one at a time. Do this before you tear it down. This way you can tell if it is a rod, main, or piston. It also tells you which cylinder or which main is knocking. It would not tell you if it is a timing gear.
I did this but not really any change in the knock.

Sent from my SM-N950U using Tapatalk
Garagekulture13 is offline   Reply With Quote