Quote:
Originally Posted by wra
here is my flattie in my 34 ford project. The adapters were found on ebay, think they were around $70 (ford part #41a-6023) i also had to cut the flange off the crank pully so it would not hit the crossmember. I plan on using the stock radiator and 46-48 distributor. Its a tight fit, less than an inch from the firewall.
Attachment 21669 Attachment 21667 Attachment 21668
|
What water pumps did you use?
What adapter do you mean?
Did you fabricate the motor mounts?
What transmission did you use?
I sure like the red paint
I sure appreciate you reply. A few pictures sure help.
Thanks