The Ford Barn - View Single Post

Kahuna · 06-21-2018, 01:20 PM

Solid Axle
I don't understand this statement at all:
Why would anything need to be modified, etc for the S.co.T.
I have a perfectly good running stock 8BA and installed a S.Co.T. blower on it. I wanted to have everything set up correctly before modifying the engine. It took a lot of thought and fabrication to fit into a 32. My new plan is to leave as is till it needs rebuilding or I get bored.
If you decide to go this way just don't push that early flathead too hard.

06-21-2018, 01:20 PM	#23
Kahuna Senior Member Join Date: May 2010 Location: NorCal Posts: 2,617	Re: Looking for input /opinions Solid Axle I don't understand this statement at all: Why would anything need to be modified, etc for the S.co.T. I have a perfectly good running stock 8BA and installed a S.Co.T. blower on it. I wanted to have everything set up correctly before modifying the engine. It took a lot of thought and fabrication to fit into a 32. My new plan is to leave as is till it needs rebuilding or I get bored. If you decide to go this way just don't push that early flathead too hard.