Radiator shell mounting flange distance
Folks - on my '30 Town Sedan the radiator shell is about an inch wider at the lower mounting points than the distance between the flanges. When tightened up the movement put a stress on the lower part of the shell to the point it folded and split at the center. Now that I have the split welded up and reinforced, it's forcing a buckle where the side curves around. Obviously this isn't right, but I don't know if the problem is the radiator mounts or the shell.
Anyone with a 30/31 have a radiator with shell off that can measure the distance between the lower shell mounting flanges? My radiator is 20-1/2" outside to outside. I'm hoping the issue is the radiator, I can more easily bend the mounting flanges (or make a spacer) than I can the shell.
Thanks in advance.
JayJay
__________________
JayJay
San Francisco Bay Area
------------------------
1930 Murray Town Sedan
1931 Briggs S/W Town Sedan
Last edited by JayJay; 06-08-2021 at 02:58 PM.
|