The Ford Barn - View Single Post - No reverse BW R-10

whb52ford · 09-18-2019, 06:01 AM

This is what I know

Side cover is off. Reverse gear activated. The side cover does have a block to push the rail #14 back when reverse is engaged. Rail pushed back so sungear should be in planetary gear. Solenoid removed so the pawl is not pushed in.
Still no reverse.

I'm sure I put the rail into the slot on the sungear. #15 can be installed 180 degrees off, but I believe I have it in the right way because the rail is moving. When I pull the OD cable out, the part of the rail 14 in the front tranny goes back flat against the housing, same as putting it in reverse the side cover reverse pushes the rail back.

So what do I do next?

Also, I just can't figure out what and how 5 works. What is it doing?

09-18-2019, 06:01 AM	#20
whb52ford Senior Member Join Date: Jan 2013 Location: Ocala, FL 34481 Posts: 235	Re: No reverse BW R-10 This is what I know Side cover is off. Reverse gear activated. The side cover does have a block to push the rail #14 back when reverse is engaged. Rail pushed back so sungear should be in planetary gear. Solenoid removed so the pawl is not pushed in. Still no reverse. I'm sure I put the rail into the slot on the sungear. #15 can be installed 180 degrees off, but I believe I have it in the right way because the rail is moving. When I pull the OD cable out, the part of the rail 14 in the front tranny goes back flat against the housing, same as putting it in reverse the side cover reverse pushes the rail back. So what do I do next? Also, I just can't figure out what and how 5 works. What is it doing?