View Single Post
Old 05-20-2019, 01:17 AM   #3
RobR'35
Senior Member
 
RobR'35's Avatar
 
Join Date: Dec 2014
Location: Upper Peninsula, Michigan
Posts: 473
Default Re: Need dimension of bearing surface axle housing race

I've read on here and wrote it down some time ago. Factory 2.061 to 2.063 max. additional wear allowed is minus 5 mils. I don't really get the mils part. I believe it means .005?
Not sure on the wear spec.completely.
I've measured on my car years ago with replaceable sleeves installed before I owned the car. Areas where the bearing didn't ride measured in the spec. I wrote above.
RobR'35 is offline   Reply With Quote