View Single Post
Old 04-20-2019, 10:21 PM   #3
larrys40
Senior Member
 
Join Date: May 2010
Location: St Charles , Missouri
Posts: 1,990
Default Re: Draglink rubs against brake actuator housing

Sponsored Links (Register now to hide all advertisements)
One of 3 problems most likely.
1. Front spring sagging and causing angle of drag link to rub on tied rod (very common) and drag link clearance and angle very close. You should see a definite gap between spring and axle.

2. Possible junk repro spring perch (older repro or otherwise ) and causing incorrect brake operating shaft alignment.

3. Bent drag link and or steering arm. Ensure steering arm flat is correctly positioned against spindle.

One of the above is my bet.
Check them out and hopefully you will see a culprit.
Larry shepard

Last edited by larrys40; 04-21-2019 at 06:51 AM.
larrys40 is offline   Reply With Quote