The Ford Barn - View Single Post

ken ct · 11-28-2012, 08:19 AM

You cut a "U" shaped cutout in the long edge the depth and width of the measurement you want to set the float at and just drop over the float when the top cover is upside down on the bench and adjust the float to the opening in the card. clear as mud right.I only use it on 94's. Stroms i use the one in the kit but leave about 1/16" space from the gauge to the float,so its slightly low. On the end NOT on the hump. ken ct.

11-28-2012, 08:19 AM	#19
ken ct BANNED Join Date: May 2010 Location: stratford,ct Posts: 5,971	Re: KRW Float Level Gauge You cut a "U" shaped cutout in the long edge the depth and width of the measurement you want to set the float at and just drop over the float when the top cover is upside down on the bench and adjust the float to the opening in the card. clear as mud right.I only use it on 94's. Stroms i use the one in the kit but leave about 1/16" space from the gauge to the float,so its slightly low. On the end NOT on the hump. ken ct.