Re: Oil filters on flatheads
Yes, I saw the pic upper top left as you said.That pic could easily be the top or the bottom, but you said bottom so that is all I did. I did miss the link. So now looked at that thread. My plug is already out of the tranny and rear because I have drained all the fluid in both and will be replacing with new fluid from MAC. I have put 2 1/2pints back in the tranny but have not filled the rear yet, so now would be an ideal time to count the ring gear teeth!I also purchased magnetic plugs for both drain and fill for tranny and rear. They wre cheap enough and I figured that fluid is so thick the chips will float rather than sink to the bottom, cheap insurance even if I am wrong! The level is confusing because I have read everything from and inch below the fill to all the way up until it runs out of the hole. i will probably compromise and go 1/2 inch below. The owners manual says capacity 2 1/2 pints for both until it runs out of the fill
|