View Single Post
Old 06-13-2018, 10:19 AM   #9
Brentwood Bob
Senior Member
 
Join Date: May 2010
Location: brentwood, ca
Posts: 4,210
Default Re: steering box mounting frame holes

What I did was trace the pattern from the factory holes in the passenger/right frame. Weld up the driver side one hole at a time, use the pattern after transfer to plate steel. Bolt pattern in place. Drill a pilot hole and finish to final hole diameter. Now bolt plate to finished bolt hole after welding up the other hole and do other hole. And since it is now summer do the work outside under a big tree
Brentwood Bob is offline   Reply With Quote