The Ford Barn - View Single Post

Mart · 09-22-2013, 04:35 AM

I can only reiterate what has been said before. Use 1/4". Copper or steel, it all works. You can buy a 1/4" compression tee fitting to split the feed from one carb to two. 1/4" pipe will flow more than enough fuel for a flathead.

Mart.

09-22-2013, 04:35 AM	#17
Mart Senior Member Join Date: May 2010 Location: Solihull, England. Posts: 8,749	Re: Looking for a compression fitting I can only reiterate what has been said before. Use 1/4". Copper or steel, it all works. You can buy a 1/4" compression tee fitting to split the feed from one carb to two. 1/4" pipe will flow more than enough fuel for a flathead. Mart.