The Ford Barn - View Single Post - How to remove blasted carrier bearings without ruining them

Res731 · 05-28-2019, 01:38 PM

HI Tom

Yes, I read the article but for the life of me I could not get the bearing puller under the bearing as you showed. The one from HF is thicker and it simple would not fit with the knife edge up. I had to install it with the knife edge down and it only connected with the cage. I tried to see if there are dimensions out there for other bearing splitters but I couldn't find anything that talks about the height (only min width, max width, bearing dimension etc.) but not actual height of the splitter .

05-28-2019, 01:38 PM	#4
Res731 Senior Member Join Date: Jun 2014 Location: Westlake, ohio Posts: 107	Re: How to remove blasted carrier bearings without ruining them HI Tom Yes, I read the article but for the life of me I could not get the bearing puller under the bearing as you showed. The one from HF is thicker and it simple would not fit with the knife edge up. I had to install it with the knife edge down and it only connected with the cage. I tried to see if there are dimensions out there for other bearing splitters but I couldn't find anything that talks about the height (only min width, max width, bearing dimension etc.) but not actual height of the splitter .