The Ford Barn - View Single Post

George Miller · 03-02-2018, 12:19 PM

earlier in the week a friend had a Model A front axle the spring perch was wore out. So we put a bushing in it with my mill.

But that is a job you could do in a Lathe. It would be a little harder but doable.

03-02-2018, 12:19 PM	#37
George Miller Senior Member Join Date: May 2010 Location: NC Posts: 2,975	Re: Making A parts with lathe earlier in the week a friend had a Model A front axle the spring perch was wore out. So we put a bushing in it with my mill. But that is a job you could do in a Lathe. It would be a little harder but doable.