Re: Truck based woody
Quote:
Originally Posted by 38bill
I actually have some EPDM rubber roofing and some Herculiner textured bed liner. I could try it out for you to see if it sticks. Just let me know.
|
I'd like that. I picture applying with a course brush. Maybe even follow up with careful 'grain' strokes with an old fashioned whisk broom. Or rolling it on and chasing with the whisk broom. I'm hoping the material isn't too thick. I plan on holding it down on the edges with a rain gutter. I have seen it in aluminum for 'canned ham' travel trailers. Sometimes called J metal. It would get painted black. When I first started this project by sawing the pickup's cab off, I was being pretty casual about the details, but after so much labor and trial and error design, I have become more uptight about the finished product. I really want it to look as if it were built in the 40s. If I went with the rubber and it's quite thick then it might not need padding or anything under it. Not too familiar with soft tops. Thanks again for all the help! Edit: Maybe a scuffing with 80 grit before the bed liner. Like we do before patching a tube. Nothing like a little bit of 'tooth' for adhesion.
__________________
Owner/Operator of 'Jailbar Ranch' on the side of Mt. Pickett. Current stable consists of 1946 1/2 ton pickup turned woodie wagon with FH V8, 1947 Tonner Pickup (red) mostly stock with exception of a cummins 6at turbo diesel, 1946 Tonner Pickup (green) with 226 cu in 6 cyl flathead, 1979 Toyota landcruiser wagon, completely encased in 1947 Ford Jailbar sheet metal. Ok, cornbinder rear fenders..... 'Rusty ol' floorboards, hot on their feet' (Alan Jackson)
|