The Ford Barn - View Single Post

DavidG · 09-06-2019, 10:01 AM

The two photos show two very different run-in procedures. The first photo (coincidentally Job #1 V8 engine at the Ford of Canada East Windsor, Ontario plant in April, 1932) shows the run-in with water being circulated through the engine. The second photo, taken at the Dearborn Engine Plant during the '34 model year, shows the run-in without water being used. Presumably the former method permitted a much longer run-in cycle.

09-06-2019, 10:01 AM	#7
DavidG Senior Member Join Date: May 2010 Location: southeastern Michigan Posts: 10,101	Re: Ford engine factory break in process The two photos show two very different run-in procedures. The first photo (coincidentally Job #1 V8 engine at the Ford of Canada East Windsor, Ontario plant in April, 1932) shows the run-in with water being circulated through the engine. The second photo, taken at the Dearborn Engine Plant during the '34 model year, shows the run-in without water being used. Presumably the former method permitted a much longer run-in cycle.