The Ford Barn - View Single Post - 1955 ford Ranchwagon/ pitman arm shaft seal.

poolplayer1 · 06-04-2019, 10:33 AM

Good Morning and thanks again guys. The thermostat is 180. When I drove the car it was 96 degrees outside.When I got back home and shut the engine off,there was no boiling water coming out of the rad at all.No leaks of any kind eighter.I think I will order a shroud and see how it does.If I can get it to run at 180 degrees,that will be good.
I will make sure that the half of the fan blades are inside the shroud and the other half are outside the shroud. Glad I asked about this,I never would of thought this about the fan having to be only halfway in the shroud. Thanks again.

06-04-2019, 10:33 AM	#10
poolplayer1 Senior Member Join Date: Sep 2015 Posts: 399	Re: 1955 ford Ranchwagon/ pitman arm shaft seal. Good Morning and thanks again guys. The thermostat is 180. When I drove the car it was 96 degrees outside.When I got back home and shut the engine off,there was no boiling water coming out of the rad at all.No leaks of any kind eighter.I think I will order a shroud and see how it does.If I can get it to run at 180 degrees,that will be good. I will make sure that the half of the fan blades are inside the shroud and the other half are outside the shroud. Glad I asked about this,I never would of thought this about the fan having to be only halfway in the shroud. Thanks again.