The Ford Barn - View Single Post - Fort Wayne clutch claims setting is correct.

jw hash · 01-04-2019, 06:12 PM

I checked the setting on a rebuilt pressure plate last month, I had two new clutch disc. one of the new disc`s was thicker then the other so when the bolted it together on the flywheel the fingers were off be 3/8" so I removed the set up and tied the thinner disc. and they pretty close to right on. so who ever put together the one disc used to thick of lining. it does not take much to throw it off. also when you have your flywheel turned they need to turn the mounting surface too. that can make a difference to.

01-04-2019, 06:12 PM	#4
jw hash Senior Member Join Date: May 2010 Location: Auburn Washington Posts: 2,552	Re: Fort Wayne clutch claims setting is correct. I checked the setting on a rebuilt pressure plate last month, I had two new clutch disc. one of the new disc`s was thicker then the other so when the bolted it together on the flywheel the fingers were off be 3/8" so I removed the set up and tied the thinner disc. and they pretty close to right on. so who ever put together the one disc used to thick of lining. it does not take much to throw it off. also when you have your flywheel turned they need to turn the mounting surface too. that can make a difference to.