The Ford Barn - View Single Post

kimeccles · 02-12-2018, 01:31 PM

I think it is one solid piece for the running board section. Only the front and back by the fenders bolt together. The rest where you get in by the splash side part is all together.

I believe this needs to have the special running board zinc trim pieces and not a separate bolt on running board like most after market ones. I have a set of separate new boards with metal support frames and rubber from Snyder's or Bratton's but they do not fit so I will probably be selling them.

After some looking in the MARC book I think these were from Jan 1930 to Sept 1930 style with it all attached to the splash shield, but so many other things are different. I think these are original but might be older 50 year aftermarket, too. Hard to tell.

02-12-2018, 01:31 PM	#4
kimeccles Senior Member Join Date: Jul 2017 Location: Spokane, Washington state Posts: 250	Re: 1930 Cabriolet running board shield I think it is one solid piece for the running board section. Only the front and back by the fenders bolt together. The rest where you get in by the splash side part is all together. I believe this needs to have the special running board zinc trim pieces and not a separate bolt on running board like most after market ones. I have a set of separate new boards with metal support frames and rubber from Snyder's or Bratton's but they do not fit so I will probably be selling them. After some looking in the MARC book I think these were from Jan 1930 to Sept 1930 style with it all attached to the splash shield, but so many other things are different. I think these are original but might be older 50 year aftermarket, too. Hard to tell. __________________ 68B frame# late May1930, fixed seat, Briggs build plate# & most parts, indicate July, or early Aug. 1930.