The Ford Barn - View Single Post

rocket1 · 11-02-2019, 03:14 PM

I was just looking through Les Andrews book and it stated the stainless valves should be cut down a quarter of an inch from the end to allow for proper adjustment,this would have allowed me to access the machined part of the lifter for my wrench to fit on.

11-02-2019, 03:14 PM	#5
rocket1 Senior Member Join Date: Mar 2014 Location: Midland Park,N.J. Posts: 1,108	Re: adjustable lifters I was just looking through Les Andrews book and it stated the stainless valves should be cut down a quarter of an inch from the end to allow for proper adjustment,this would have allowed me to access the machined part of the lifter for my wrench to fit on.