The Ford Barn - View Single Post

holdover · 10-09-2018, 03:23 PM

"why is so dang hard to get a replacement axle" I would say to cost to manufacture a new unit , to the tolerance needed is pretty high, and with the cost high and demand low for a new one it would not be something the vendors would take on.. With all the good used ones around they a easy to come by. Most swap meets have a few and I would venture if you contacted a local club they could fix you up. best of luck...

10-09-2018, 03:23 PM	#19
holdover Senior Member Join Date: May 2011 Location: SW Virginia near the Blue ridge Parkway Posts: 674	Re: Front axle repair or replacement "why is so dang hard to get a replacement axle" I would say to cost to manufacture a new unit , to the tolerance needed is pretty high, and with the cost high and demand low for a new one it would not be something the vendors would take on.. With all the good used ones around they a easy to come by. Most swap meets have a few and I would venture if you contacted a local club they could fix you up. best of luck...