View Single Post
Old 03-23-2021, 10:46 PM   #13
GB SISSON
Senior Member
 
GB SISSON's Avatar
 
Join Date: Jan 2014
Location: Orcas Island Washington
Posts: 4,929
Default Re: Covid excuse to play hookey

I don't think I have ever seen or read of old ford (or chevy)sheet metal set on a japanese 4x4 before. These landcruisers are a very rugged and dependable vehicle. They also have a narrow, boxed ladder frame and a track width about like most prewar stuff. PS, PDB, 3.73 gears, inline six. The axle shafts are about 20% larger in diameter than my 92 f350's. I see a lot of folks using s10 and ranger stuff, but as I have so often stated, I like to use up all the junk I have collected over the years, so my kids don't have to scrap it later.. I have the back of a shed and an attic full of landcruiser stuff, and even more early ford truck parts scattered about. After all this time I think it was inevitable that these parts would comingle in the hayloft one night and produce offspring.
__________________
Owner/Operator of 'Jailbar Ranch' on the side of Mt. Pickett. Current stable consists of 1946 1/2 ton pickup turned woodie wagon with FH V8, 1947 Tonner Pickup (red) mostly stock with exception of a cummins 6at turbo diesel, 1946 Tonner Pickup (green) with 226 cu in 6 cyl flathead, 1979 Toyota landcruiser wagon, completely encased in 1947 Ford Jailbar sheet metal. Ok, cornbinder rear fenders..... 'Rusty ol' floorboards, hot on their feet' (Alan Jackson)
GB SISSON is offline   Reply With Quote