Quote:
Originally Posted by ericr
good topic, with no easy solutions. years ago I saw ads for services that would build up the bottom side with weld then replate it, but I have not seen that offered for a long time. I have read about fitment problems with the repros, as one member has said. As I recall the complaint was that the 90 degree bend was not defined enough
getting the lower springs on and off is challenging, as is replacing the anti-rattlers within the tube.
too bad the later columns did not use the replaceable quadrant that the earlier versions did.
|
I replaced both of mine, last spring with new ones from Berts. They fit and work perfectly.