[walkerlakeprinter]

I installed my hinge mirror today. I used the pin removal tool from Snyders and it worked easily. I soaked the pin with PB Blaster last night and did not have any problem at all.



The only questions I have: Are the small set-screws really needed? They stick out so far, I am thinking I either need to leave them off or cut them down. Also, it seems the acorn nuts to attach the hinge pin and the mirror head must be metric.....3/8 is too small, 7/16 is too big, 11mm almost works, but I could not find my 10mm. Handy adjustable crescent always works....if I can find it.