02-16-2020, 02:28 PM
|
#9
|
Senior Member
Join Date: Jul 2011
Location: Redondo Beach, CA
Posts: 5,849
|
Re: A big job ahead
Quote:
Originally Posted by sphooch
I was just on this site with my Pitnam arm fix and now I have a new problem while working on the pitman arm I saw the drag link was rubbing on the tie rod. looking at the Les Andrews books I did the required measurements and as such determined the front spring should be replaced.i found on this site A-Spring made in the U.S.A. was the best. is this a big job, can some tell me if the Les Andrews replacement instructions are enough or are there some other things I should be aware of. thanks again THE HOOCH
|
I just replaced the front spring on my Town Sedan.
I got the spring from "A" Springs (http://www.a-springs.com/products.html), bushing pre-installed. I replaced the shackles and bushings in the spring perches at the same time. It took me less than an afternoon to install (after paint was dry), working by myself. I have a spring spreader but some use 2X4s.
|
|
|