The Ford Barn - View Single Post

tommyleea · 12-09-2019, 12:33 PM

Now that the front yoke is taken care of I have a question about the rear universal joint. I don't have the hardware that clamps the ujoint to the rear yoke. I don't see threads in the holes of the yoke. Is anyone familiar with what hardware I should have? Would it be u bolts or the wider clamp plates with washers and nuts? I see Denny's driveshaft has a NEAPCO 1-2134 which they call a winged ujoint, but that is not what I removed. Any help is appreciated. I have the flathead engine with 3 speed tranny.

12-09-2019, 12:33 PM	#5
tommyleea Senior Member Join Date: Jul 2016 Location: Missouri Posts: 424	Re: 53 Ranchwagon driveshaft Now that the front yoke is taken care of I have a question about the rear universal joint. I don't have the hardware that clamps the ujoint to the rear yoke. I don't see threads in the holes of the yoke. Is anyone familiar with what hardware I should have? Would it be u bolts or the wider clamp plates with washers and nuts? I see Denny's driveshaft has a NEAPCO 1-2134 which they call a winged ujoint, but that is not what I removed. Any help is appreciated. I have the flathead engine with 3 speed tranny.