Re: Convertible top for a 1953 Mercury
I now have all the information I need to duplicate the "piece" in question. It is 2 1/4" high by 40 9/16" wide, and is made out of 16 gauge steel. The first hole is 3/8" on center, to the top and left edge. 13 screws, each 3 1/2" on center from the other. #10 3/4" sheet metal screws.
Trip to DenCol to pick up the piece, drill the holes and install, after I get I get a new taking strip to put in the valley on the left, where this mounts.
Not sure if anyone is still following this, but if you are, now you have the answer.
Last edited by Merc Cruzer; 07-26-2020 at 12:42 PM.
|