View Single Post
Old 09-21-2016, 08:12 AM   #20
51 MERC-CT
Senior Member
 
51 MERC-CT's Avatar
 
Join Date: May 2010
Location: East Hartford, Ct
Posts: 4,340
Default Re: PCV parts verification

Quote:
Originally Posted by scooder View Post
A properly installed PCV on an 8BA would draw air through the oil fill cap, this has a wire mesh filter in it. So I think it will be fine.
Infact any properly installed PCV on a Flathead will/should draw in via its mesh filtered oil fill.
Martin.
Been there, done that and then decided to do it the correct way by using a sealed Mopar PCV filler cap and connecting to a neutral air pressure point on the carb. air cleaner as both Mopar and Ford did.
Attached Images
File Type: jpg MOPAR PCV.jpg (57.1 KB, 43 views)
__________________
DON'T RECALL DOING SOMETHING FOR MYSELF BASED ON SOMEONE ELSE'S LIKES OR DISLIKES
51 MERC-CT is offline   Reply With Quote