Quote:
Originally Posted by Jacksonlll
If you are drawing that much current, then something is getting warm or even hot. Look for it. Usual suspects are: lights, including the brake light, generator trying to motor, short down stream of coil, Some little wire getting very hot. Good luck.
|
I started looking for something warm, and it turns out the coil is warm.
Here is something else odd. With the cutoff power “on,” and the ignition key “on,” I get 6 volts to the moving point arm when the points are open, as expected. However, under the same scenario, but with the ignition key “off,” I get still get .3 volts on the moving point arm.
Sent from my iPhone using Tapatalk