View Single Post
Old 10-23-2017, 06:47 PM   #20
newshirt
Senior Member
 
newshirt's Avatar
 
Join Date: Jan 2011
Location: Colorado Springs
Posts: 867
Default Re: Knocking after installing new flywheel

Quote:
Originally Posted by Tom Endy View Post
If you installed a new throw-out bearing check to see if it has the word Aetna stamped on the side. This is a notoriously poor quality reproduction that flooded the hobby a few years back. They will fail coming out of the box. If it is, I would replace it. Bratton's carry a good quality Federal Mogul brand bearing, even though made in Mexico.

Tom Endy
I have the Federal Mogul throw-out bearing. I re-verified that it turns freely without clicks or drag. I also re-verified the pilot bearing.

BTW, the knock sounds like a little tack hammer on a granite countertop. Very distinct and sharp, like metal on metal. It starts as a click, then builds to a full knock if I keep pushing the clutch petal. Oddly, it remains after removing my foot from the clutch. Shutting the engine off is the only remedy.
Attached Images
File Type: jpg 20171023_163847.jpg (27.0 KB, 17 views)
__________________
Ray White
newshirt is offline   Reply With Quote