Quote:
Originally Posted by quickchange
Sounds like a tooth loose in the trans, If it blew a hole in case then problem is in the trans . Or we need more history on box. rear end etc , Been fine up till now or what ? How close did you inspect each trans , Looked or had apart ?? Same top ?? Selector fork located correct. ??
|
I should have inspected the first trans more carefully. I looked at the second trans and the inside looked really good. Clean oil no broken teeth. I did not reuse my original shifter as I thought it would be best to use the one that was originally on the second trans.
I am thinking that maybe it's the ujoint? Could excessive slack with it allow the main shaft to move under load to cause the gears to hit the case?
Thanks for the help!
RGG