Well the first two coils that I had tried tested 4.2 and 3.7 ohms when the multi-meter leads were placed on the pos and neg terminals. When the secondary circuit was tested they had readings of 9.14 and 8.39 K ohms. The NOS NAPA 6 volt, Echlin coil that I installed today had readings of 1.5 ohms on the primary circuit and 9.53 K ohms on the secondary. While I don't pretend to know much about this situation, I do know that the spark was much stronger with this latest coil.
As far as condensers are concerned, I have tried 3 different ones but currently have a genuine FoMoCo one in place with a Motorcraft set of points. The other condensers are of unknown origin.
I'm hoping there's a light at the end of the tunnel and that it's not a train
