The Ford Barn - View Single Post - 1928 transmission case lacking holes for throw out carrier

GRutter · 12-24-2017, 08:26 PM

That would also be my guess. MultiDisk clutch used a different setup, including bell housing, trans shaft, throwout bearing etc. But I believe the only difference in the transmission housing is that there were no holes tapped that would be needed for the snout.

12-24-2017, 08:26 PM	#3
GRutter Senior Member Join Date: Sep 2017 Location: Mint Hill, North Carolina Posts: 386	Re: 1928 transmission case lacking holes for throw out carrier That would also be my guess. MultiDisk clutch used a different setup, including bell housing, trans shaft, throwout bearing etc. But I believe the only difference in the transmission housing is that there were no holes tapped that would be needed for the snout.