The Ford Barn - View Single Post - Victoria Steelback -- Seats--

Pmsqrd · 09-09-2018, 08:20 PM

An early Vic uses the three position brackets that bolt to the floor. A rod goes thru the brackets and a plate with a tube on the bottom of the seat. A radiator support rod can be shortened to be used as the rod on each seat. A windshield slide knob was used to secure the threaded end of the rod. The tubes on the seats and the brackets on the floor are reproduced and worked fine for me. You might consider joining the Victoria Assiciation and purchasing the model specific restoration manuals they sell for a Vic.

09-09-2018, 08:20 PM	#3
Pmsqrd Senior Member Join Date: May 2010 Location: Sacramento, CA Posts: 216	Re: Victoria Steelback -- Seats-- An early Vic uses the three position brackets that bolt to the floor. A rod goes thru the brackets and a plate with a tube on the bottom of the seat. A radiator support rod can be shortened to be used as the rod on each seat. A windshield slide knob was used to secure the threaded end of the rod. The tubes on the seats and the brackets on the floor are reproduced and worked fine for me. You might consider joining the Victoria Assiciation and purchasing the model specific restoration manuals they sell for a Vic.