View Single Post
Old 06-30-2020, 11:53 AM   #2
Jim Brierley
Senior Member
 
Join Date: Jun 2010
Location: Temecula, CA
Posts: 3,401
Default Re: G28T center cam bearing oiling?

I've never done a G-28, but have pressurized many B blocks. I didn't realize the pump didn't exhaust like on a B. A small amount of oil will go thru the upper bearing of the pump, maybe enough? Is there a hole in the galley to that brg.? You could file a very small flat on the upper end of the pump if you think it necessary. There must be a way, put in at the factory, those engines lasted a long time. I ground a cam for one years ago and was surprised the original cam had the Model A profile, not the B. This engine was out of a farm machine of some sort so maybe they did the cam to have the torque curve where they wanted it???
Jim Brierley is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)