View Single Post
Old 11-23-2019, 11:09 PM   #8
Old Henry
Senior Member
 
Old Henry's Avatar
 
Join Date: Oct 2010
Location: Orem, Utah
Posts: 5,616
Default Re: 47 generator rear bushing

Thanks for all the info.

Two more questions:

1. Since I don't have a tap to thread the bushing nor chisel to chisel it out, I wonder if this extractor for broken off plastic pipe could do the job.

2. If I'm not sure the new bushing is "Oilite" that allows the oil to soak through from the oil reservoir I wonder about drilling just the smallest hole through the bushing to allow the oil from the reservoir to enter the wear surface.

Ideas?
Attached Images
File Type: jpg Bushing Extractor.jpg (81.7 KB, 9 views)
__________________
Prof. Henry (The Roaming Gnome)
"It is good to have an end to journey toward; but it is the journey that matters, in the end. *Ursula K. Le Guin in The Left Hand of Darkness
Old Henry is offline   Reply With Quote