The Ford Barn - View Single Post

QGolden · 11-23-2013, 08:31 PM

Good, yes first and last are the same arch, reversed. If you notice on photo 2, I make the chalk marks on the inside of the arch. If you blow up the last photo you see there are no chalk marks on the inside, 'cause they are now on the outside.

I have a number of attachments that I have made for the press, I have used it for pressing cartridge type wheel bearings, and straightening any number of items, including every bent tankers bar in the neighborhood. I formed some of the parts for my current speedster with it. Not quite a shop press, but real handy for the $80.00 it cost.

11-23-2013, 08:31 PM	#101
QGolden Senior Member Join Date: Sep 2011 Location: Alton, NH Posts: 1,231	Re: Speedster Kit Good, yes first and last are the same arch, reversed. If you notice on photo 2, I make the chalk marks on the inside of the arch. If you blow up the last photo you see there are no chalk marks on the inside, 'cause they are now on the outside. I have a number of attachments that I have made for the press, I have used it for pressing cartridge type wheel bearings, and straightening any number of items, including every bent tankers bar in the neighborhood. I formed some of the parts for my current speedster with it. Not quite a shop press, but real handy for the $80.00 it cost. __________________ It's not what people think they know that will hurt them, it is what they think they know that aint so! -Mark Twain. It is the very things that we think we know, that keep us from learning what we should know.- Unknown