The Ford Barn - View Single Post

scooder · 08-09-2018, 10:13 AM

Nah, if it's a coper gasket, installing it and toqueing it down for measurement purpose, won't make it a used gasket. Just refit to the same side, it'll be as good as new.
You can also grease the felpro type ones and use them as above.
With the coper gaskets you can use um a good few times without a worry.
I believe ol Ron does this as well.
Martin.

08-09-2018, 10:13 AM	#27
scooder Senior Member Join Date: Jul 2010 Posts: 2,593	Re: Piston to head clearancing Nah, if it's a coper gasket, installing it and toqueing it down for measurement purpose, won't make it a used gasket. Just refit to the same side, it'll be as good as new. You can also grease the felpro type ones and use them as above. With the coper gaskets you can use um a good few times without a worry. I believe ol Ron does this as well. Martin.