Re: Bent chassis
It sounds like this is a pretty much together car so you have some obstacles. I would begin by confirming that the frame is equal at all 4 points of the jack stands. From there you need to strt finding some reference points to determine exactly where the frame is out of alignment. I am not familiar with these frames so cannot be specific but in the end you're just trying to make a box square.
Maybe someone with a frame like yours off the car can give you a few measurements. Good luck.
Oh yeah, maybe take a shower. Lot's of good ideas develop there sometimes. We joke about that at work.
__________________
“The technique of infamy is to start two lies at once and get people arguing heatedly over which is true.” ~ Ezra Pound
|