The Ford Barn - View Single Post - Y-block distributor wrench ?

packrat5 · 07-05-2020, 09:32 PM

No, it's not a 9/16, it's a 1/2. You can just use a short 1/2 box end wrench, but most guys tighten them down to at least 95# torque so that might be difficult. Anyway, Snap-on S8564B is the correct one, but S9707 will also work tho in my estimation, not as well in a tight situation. They will pretty much work on all Fords.

07-05-2020, 09:32 PM	#5
packrat5 BANNED Join Date: Mar 2015 Location: Wisconsin Posts: 301	Re: Y-block distributor wrench ? No, it's not a 9/16, it's a 1/2. You can just use a short 1/2 box end wrench, but most guys tighten them down to at least 95# torque so that might be difficult. Anyway, Snap-on S8564B is the correct one, but S9707 will also work tho in my estimation, not as well in a tight situation. They will pretty much work on all Fords.