Re: '40 Oil Filter Canister
Hi cas3,
If you look at the picture in a prior post of the canister I purchased, the input fitting that actually goes into the canister is the "restrictor fitting" with the .060" hole in it. The male and female threads on this fitting are both 1/8-27NPT. The second fitting is a 45 degree elbow with 1/8-27NPT male threads and with female threads for an inverted flare male fitting. The 90 degree fitting on the bottom of the canister has the same male and female threads as the 45 degree elbow. Based on your post, and what I've read elsewhere, I think this is what I need to make the proper line connections.
Thanks, again, for your advice.
Best,
Borron
|