Quote:
Originally Posted by Terry,NJ
I have a old compressor to which I added a vintage Binks regulator. The two halves have a gasket (Approximately 2" dia.) between them. The gasket blew out and I replaced it with one I made from gasket paper. That worked well for about two days and the paper failed. I'm considering cutting up a plastic milk carton, etc. Any suggestions on what I should use? This gasket is on the high pressure side of the regulator.
Terry
|
Terry,
Have you tried getting the parts from a Binks distributer, there should be a part number on that regulator, usually a boss with something like 85-125, post a photo if you can.
Is it round or fluted where the screws go through.
There is more to that diaphragm than the gasket material, there is a metal cup riveted to the center to retain the adjustment screw spring.
I collect Binks stuff.
Darryl in Fairbanks