The Ford Barn - View Single Post

kingskid · 09-19-2021, 10:06 PM

Thanks for the replies. I was able to use clear plastic tubing over the screws.
Two duce set up too close to get hand in there. What is the correct setting on these? Many different suggestions. From 1/2 - 1 1/2?
As you can tell I'm new to this. Was checking the carbs off the car- one has throttle plates in the base, the other one doesn't. What's up with that? I just got the car 47 Bus. coupe. Running real rich. Offy. heads and intake, 2- 97's,
Isky #77 cam, Fenton cast iron headers. suggestions? Thanks, kingskid.

09-19-2021, 10:06 PM	#10
kingskid Member Join Date: Nov 2010 Location: Denver, NC Posts: 44	Re: Stromberg 97 adjust Thanks for the replies. I was able to use clear plastic tubing over the screws. Two duce set up too close to get hand in there. What is the correct setting on these? Many different suggestions. From 1/2 - 1 1/2? As you can tell I'm new to this. Was checking the carbs off the car- one has throttle plates in the base, the other one doesn't. What's up with that? I just got the car 47 Bus. coupe. Running real rich. Offy. heads and intake, 2- 97's, Isky #77 cam, Fenton cast iron headers. suggestions? Thanks, kingskid.