The Ford Barn - View Single Post

Kentmac · 11-08-2018, 03:06 PM

I finally found one in Michigan that I may get later this week. Thanks to everyone for their advise about this. My next question is, how hard is it to get the old one off. I assume that I will need to remove both fenders. Can this be done with the engine in the vehicle? I suppose grinding the rivets off would be best approach though I haven't looked it over enough to know how difficult that would be.

11-08-2018, 03:06 PM	#30
Kentmac Member Join Date: Sep 2016 Location: Manchester, Mich Posts: 40	Re: Front cross member needed badly I finally found one in Michigan that I may get later this week. Thanks to everyone for their advise about this. My next question is, how hard is it to get the old one off. I assume that I will need to remove both fenders. Can this be done with the engine in the vehicle? I suppose grinding the rivets off would be best approach though I haven't looked it over enough to know how difficult that would be.