07-13-2020, 09:44 AM
|
#9
|
Senior Member
Join Date: Aug 2016
Location: Alberta
Posts: 930
|
Re: Modern one piece valve guide removal
Quote:
Originally Posted by BRENT in 10-uh-C
Go a different direction with it. Use a 23/64 drill bit to enlarge the hole and then thread the inside of the guide with a 7/16-14 tap. Screw a piece of threaded rod into the guide and set-up a bridge across the seat area. Use a well-lubed nut and flat washer to pull the threaded rod upwards. You will need to build the bridge high enough, -or use a piece of 2" pipe to raise the pulling nut high enough for guide clearance as it comes out.
|
That's a great idea.
|
|
|